Wall To Wall Installation Guide

CATEGORY
 

Wall To Wall Installation Guide

The Advantage Wall to Wall runs along a wall with a wall at each end. This drain is designed so that only the drain grate is visible between the tiles. The Advantage Wall to Wall was designed for use indoors, but is perfectly suitable for outdoor use too. Please download the full PDF for print for your convenience here.

 

Step 1.

Mark out floor area to suit drain size.

 

Step 2.

Remove floor area to gain access to floor joists, add additional floor joist support if necessary.

 

Step 3.

Plane down joists to create desired fall as per diagram.

 

Step 4.

After fall has been created, install new floor, leaving room for new drain at rear.

 

Step 5.

Check that the drain fits prior to installing ceramic tile underlay.

 

Step 6.

After installing the ceramic tile underlay, re-check the drain fit. Drill fixing points to drain.

 

Step 7.

Install drain using sealant and 20mm stainless steel clouts or similar.

 

Step 8.

Fit over-flashing with sealant. Your bathroom is now ready for final waterproofing and tiling.